How can I install a subwoofer if the car stereo does not have an output ? - car stereo suppressor
Hello everyone, thank you for reading my question!
I have a subwoofer and amplifier from my old car and would like my new car (Toyota Highlander) to install. The CD is the original population, and I have the dashboard and see what are the optional products you back in the. In fact, I had a subwoofer output. When I asked car audio department at Best Buy, you can use a splitter (I am not sure if correct) and get the right cables with the speakers at the door.
I know if my car audio business, which can quickly do. TSD, but wants the car for a few days driving vacations, because I have every day. Someone has already done this? Is there a Web site for the installation of the splitter or sell order that I mentioned above? Thank you all!
Sunday, January 31, 2010
Car Stereo Suppressor How Can I Install A Subwoofer If The Car Stereo Does Not Have An Output ?
5 comments:
In fact, probably 99.9% of the factory radio is not limited outputs (I had a Mazda MX-6, once done).
1) You, the so-called "high" that many inputs (particularly economically) can AMPS functionality. It is usually taken with four son to go directly to an amplifier output current, usually in conjunction with the positive and negative on the left and right speakers. You can do this by either the speaker or behind the radio.
2) Connect the high-and low-adapter, connector, and input from top level but the signal below a first level, and then use an RCA cable to connect to the amplifier.
You need a separate stereo or aftermarket
How do you connect your factory stereo? in the interest of a better sound system, I suggest you take some time, and while you to replace it with an aftermarket. Factory radio in general, are under 10W per speaker which is not sufficient. Add the RCA cleaning for all secondary and justify the hundreds of dollars.
If you want to keep the stereo mode, you need a cable and an audio output signal with the strength and mass. Rely on the probe and welding cables to start the new car from Nice? If so, the production of splice signal cable cutting means of isolating the son of the existing speakers and Lot the son of the signal from your (18a should work for them). not a signal cable that allows you a warm start (key) to find cable to solve backups. Ideally, you should use a secure exchange of holes and installation of a shovel with a fuse in line. less than one amp. It merges the power cord (4a) with the battery. 40 amps is widespread.
Fun.
(sighs) It was called LOC or line out converter and you can find one at Wal-Mart.
There are two ways to do this, and are usually on a wire for the amplifier and configuration that goes with the speakers. Amplifiers of the most common 2 or 4 channels, 2 channels, if you need to have speaker cable channel by the first time is executed and a second channel in two ways. If the amplifier has a crossover, which states that the high frequencies on which the sub-committee wants to eliminate strikes, or if the installation of a cross between the amplifier and vice-committee need not be expensive courier, we Cheap Trick to do, but few want to invest they should be allowed to be based on the amount of other things, value and high quality components. Information is the same intersection a 4-channel amplifier, even if a 4-channel amplifier, you need the first two channels to your car speakers, you might use 1 channel for front and rear of a channel or left / right But the second series of channels under the bridge (if the amp can handle it). Bridge by tthe position of a channel back to the sub-committee and the neg to a different channel. Replace the filter and adjust accordingly get your party started. Hope this helps.
C
Post a Comment